When the printer has successfully made a connection to your wireless network, the Power and Wi-Fi lamps will stop flashing and remain lit. The blue Wi-Fi lamp on the printer will continue to flash while searching, and the Power and Wi-Fi lamps will flash when connecting to the access point.Ħ. ![]() Press the button, and make sure that the ON lamp (E) and the Wireless lamp flash, then press the button on the wireless router within 2 minutes. Press the button until the Direct lamp (D) lights up.ĥ. ![]() Press and hold the button (A) on the printer until the Wireless lamp (B) flashes.Ĥ. ![]() Make sure the wireless router is in range of the printer and the WPS button is ready to be pressed.Ģ. Please follow the steps below to complete the setup -ġ. For details on which security method is being used on your wireless network, please check the wireless connection settings on your computer. Most WPS enabled access points will not connect using the WPS method if the WEP (Wired Equivalent Privacy) security method is used, or if no security is enabled. Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol.The access point must have a physical WPS push button available, please check with your device’s user guide for details. ![]() Before we start, there are however some conditions that must be met in order to use the WPS pushbutton method:
0 Comments
Leave a Reply. |